Filter
Top Products
51
OPL MODELS
1. Microprocessor (computer) Board
a. Upon completing installation of the replacement microprocessor (computer) board, reestablish power to
the dryer.
b. Start the drying cycle.
c. Verify that the motor(s) and the heat indicator dots, in the microprocessor (computer) L.E.D. (light
emitting diode) display are on. (Refer to the illustration below.)
d. Verify that motor(s) heat, and door indicator lights on the back side of the microprocessor (computer)
board are lit. (Refer to illustration below.)
1) Basket (tumbler) in Forward Mode (clockwise [CW]) indicator.
2) Basket (tumbler) in Reverse Mode (counterclockwise [CCW]) indicator.
3) Heat on indicator.
4) On indicator (dryer is in operation).
5) Air Jet indicator.