Filter
Top Products
39
b. Select Temperature...
The dryer will start, the L.E.D. (light emitting diode) display will read the temperature cycle selected, and
the drying time portion of the L.E.D. (light emitting diode) display will read “00” and count upward as time
elapses, or the vended time will count downward, depending on the program parameter setting.
IMPORTANT: If the door is opened during a cycle, both the heat and motor will stop. However, the
microprocessor controller (computer) will continue to count the time, either upward or
downward, depending on which parameter is programmed. Continuation of the cycle
will resume only after the door has been closed and any other of the three (3)
temperature selection buttons is again depressed.
c. Once the preprogrammed dryness level and cool down period has been reached or the maximum automatic
time has expired, whichever comes first, the tone (buzzer) will sound for five (5) seconds, and the L.E.D.
(light emitting diode) display will read “donE,” at which time the dryer will shut off.
NOTES: 1. If the Anti-Wrinkle program is active, the L.E.D. (light emitting diode) display will continue
to read “donE,” and the microprocessor controller (computer) will proceed through the
Anti-Wrinkle program until the maximum “Active Guard Time” has expired or until the
door is opened, whichever comes first. The L.E.D. (light emitting diode) display will read
“FILL” and/or “Amount to Start.”
2. If the Anti-Wrinkle program is not active or in use, the L.E.D. (light emitting diode) display
will read “FILL” and/or “FrEE.”
4. Non-Microprocessor (Non-Computer) Models
a. Turn power on to the dryer.
b. Insert coin(s) - rotary meter type ONLY.
c. Select temperature by using rocker switch and selecting “HI TEMP,” “LO TEMP,” or “PERM PRESS.”
d. Press “Push to Start” button to start the cycle.
e. Upon completion of the drying and cooling cycles the dryer will shut off.
NOTE: If the door is opened during a cycle, both the heat and motor will stop. Continuation of the
cycle will only resume after the door has been closed, and the “Push to Start” button is pressed.
OPL MODELS
NOTE: Before attempting to start the dryer make sure the main door is closed and the lint drawer is
securely in place.
1. To start the dryer:
a. Microprocessor (computer) dryers ...