Filter
Top Products
44
SECTION VII
TROUBLESHOOTING
IMPORTANT: YOU MUST DISCONNECT and LOCKOUT THE ELECTRIC SUPPLY and
THE GAS SUPPLY BEFORE ANY COVERS or GUARDS ARE REMOVED
FROM THE MACHINE TO ALLOW ACCESS FOR CLEANING,
ADJUSTING, INSTALLATION, or TESTING OF ANY EQUIPMENT per
OSHA (Occupational Safety and Health Administration) STANDARDS.
The information provided will help isolate the most probable component(s) associated with the difficulty
described. The experienced technician realizes, however, that a loose connection or broken/ shorted wire may be
at fault where electrical components are concerned...and not necessarily the suspected component itself.
IMPORTANT: When replacing blown fuses, the replacement must be of the exact rating as the fuse
being replaced The information provided should not be misconstrued as a handbook
for use by an untrained person in making repairs.
WARNING: ALL SERVICE and TROUBLESHOOTING SHOULD BE PERFORMED BY
A QUALIFIED PROFESSIONAL OR SERVICE AGENCY.
WARNING: WHILE MAKING REPAIRS, OBSERVE ALL SAFETY PRECAUTIONS
DISPLAYED ON THE DRYER or SPECIFIED IN THIS MANUAL.
ITEM PAGE
NO L.E.D. DISPLAY ............................................................................................................. A 46
DRIVE MOTOR DOES NOT START ..........................................................................................
B 46
DRIVE MOTOR (REVERSING MODELS ONLY) OPERATES IN ONLY ONE DIRECTION ....................... C 46
DRIVE MOTOR OPERATES FOR A FEW MINUTES THEN STOPS ..................................................
D 46
BLOWER/FAN MOTOR (REVERSING MODELS ONLY) DOES NOT START ........................................ E 47
BLOWER/FAN MOTOR (REVERSING MODELS ONLY) OPERATES FOR A FEW MINUTES THEN
STOPS ..........................................................................................................................
F 47
BLOWER MOTOR AND FAN MOTOR (REVERSING MODELS ONLY) BOTH DO NOT START ............. G, H 47
BLOWER MOTOR AND FAN MOTOR (REVERSING MODELS ONLY) OPERATES FOR A FEW MINUTES
AND BOTH STOP ............................................................................................................ I 47 AND 48
L.E.D. DISPLAY READS "dSFL" ............................................................................................
J AND P 48 AND 49
L.E.D. DISPLAY READS "door" ............................................................................................. K, L 48
TABLE OF CONTENTS
(FOR TROUBLESHOOTING)
MICROPROCESSOR (COMPUTER) MODELS