Filter
Top Products
19
2. Electrical Service Specifications
a. Gas Models
IMPORTANT: Figures shown are for Non-Reversing Models ONLY. For reversing models contact
the factory.
IMPORTANT: The dryer must be connected to the electric supply shown on the data label that is
affixed to the back of the dryer, at the upper right hand corner. In the case of
208 VAC or 230/240 VAC, the supply voltage must match the electric service
specifications of the data label exactly.
IMPORTANT: The wire size must be properly sized to handle the related current.
WARNING: 208 VAC and 230/240 VAC ARE NOT THE SAME. Any damage done to dryer
components due to improper voltage connections will automatically VOID THE
WARRANTY.
NOTE: ADC reserves the right to make changes in specifications at any time, without notice or
obligation.
ADG-758 (Gas)
ELECTRICAL SERVICE SPECIFICATIONS (PER DRYER)*
SERVICE
VOLTAGE
PHASE
WIRE
SERVICE
APPROX.
AMP DRAW
CIRCUIT
BREAKER
60 Hz 50 Hz
120 1ø 2 12 -- 25
208 1ø 2 7 -- 15
240 1ø 2 7 4 15
208 3ø 3 3 -- 15
240 3ø 3 3 3 15
380/400 3ø 3/4 -- 2 15
416 3ø 3/4 -- 2 15
460/480 3ø 3/4 2 -- 15
* Contact factory for electrical information not listed.