Filter
Top Products
5
SECTION II
MECHANICAL
A. TO REMOVE LINT DRAWER
1. Pull out lint drawer 3/4’s of the way (approximately 20 inches [50.8 cm]).
2. Reach up into the back of the lint drawer and pull down the retainer (hinge) that is attached to the top of the
lint drawer.
3. The lint drawer can now be removed.
4. Reverse procedure for reinstalling the lint drawer.
B. TO REMOVE CONTROL (MIDDLE) OR LINT (LOWER) DOOR
1. Pull out lint drawer 3/4’s of the way (approximately 20-inches [50.8 cm]). Reach into the back of the lint
drawer and push down the retainer (hinge) that is attached to the top of the lint drawer.
2. Pull out the lint drawer.
3. Open the control/lint door; two (2) 1/4 turn locks, one (1) on each side.
4. Remove the control/lint door.
5. Reverse procedure to reinstall the control/lint door.
C. TO REMOVE GAS VALVE TRAIN ASSEMBLY
1. Discontinue power to the dryer.
2. Close ALL gas shutoff valves in the gas supply line to the dryer.
3. Remove the lint drawer and the control/lint door from the dryer (follow Lint Drawer and Control/Lint
Door Removal Procedures in Section A and Section B).
4. Close the union shutoff valve at inlet area of the gas valve.
5. Loosen the union shutoff valve collar nut ALL the way.
6. Pull out gas valve train assembly 1/4 of the way. Disconnect the gas valve harness power connector at the
top of the assembly.
7. Gently pull/remove the gas valve train assembly.