Filter
Top Products
14
IMPORTANT: When installing the new Dual Microprocessor Controller (DMC) computer, make sure
that the transformer on the DMC computer is located at the bottom area of the control
panel.
9. Reverse Step #1 through Step #6.
NOTE: When reconnecting the optic switch harness connector for single coin acceptor models,
connect the harness to the lower of the two (2) connectors on the DMC computer.
NOTE: For models with the dual coin option, the lower denomination harness connector (red/green
and orange wires) are connected to the lower connector on the DMC computer. The higher
denomination harness (black/green/orange wires) are connected to the higher connector on
DMC computer.
N. TO REPLACE KEYBOARD (TOUCH PAD)
1. Discontinue power to the dryer.
2. Remove the lint drawer and the control door from the dryer (follow Lint Drawer and Control/Lint
Drawer Removal Procedures in Section A and Section B).
3. Remove screw located in the bottom right hand corner of the control panel.
4. Open the control panel and disconnect keyboard (touch pad) ribbon connector from the DMC computer by
holding onto the blue ribbon connector and pulling outward.
5. Remove the “U” shaped coin reject/return holder located on the bottom of the keyboard (touch pad) by
removing the two (2) hex nuts (with a 1/4” nut driver) at the back side of the control panel securing the “U”
coin reject/return holder to panel.
6. Peel the keyboard (touch pad) off the panel. The ribbon cable/connector will come out through the slot in
the control panel.
7. To replace the keyboard (touch pad), peel the paper backing off the new keyboard (touch pad). Put the
ribbon cable/connector through the slot in the control panel. Holding the new keyboard (touch pad) close
to the panel, align it into position and gently press into place.
8. Replace the “U” shaped coin reject/return holder removed in Step #5.
9. Reverse Step #1 through Step #4.