Filter
Top Products
39
Telephone: (508) 678-9000
Fax: (508) 678-9447
B. VENDING NOZZLE ADJUSTMENT
Dispensing nozzle can be adjusted to direct water into the center of the bay. Nozzles come from the
factory already adjusted. If flow is severely off center, it may indicate the machine is not level. Check
machine before adjusting nozzles.
1. Determine from the front of the machine which way the nozzle is aiming at. Let’s say it is too far
right and forward.
2. Open vending machine computer door and stand behind it. Facing the nozzle adjustment bolts,
loosen the left and right mounting bolts (diagram 23). Tap solenoid mounting bracket to YOUR
LEFT to correct a flow too far to the right and vice versa. (when looking at flow from front of door)
3. Front and read adjustments are corrected by loosening and tightening the front and rear bolts.
Loosen the lock nuts on the adjusting bolts. If flow is too far forward, loosen the bolt FARTHER
FROM YOU. If bolt is already at the end of its adjustment, then tighten the other bolt. Tighten left
sand right mounting bolts before checking flow. Tighten lock nuts when adjustment is completed.
C.TUBING AND FITTING REPLACEMENT TECHNIQUE
There are two types of tubing attachment methods used on this vending machine. One is the push-in
type and the other is the plastic clamp type.
PUSH-IN TYPE:
To remove a push-in tubing, push ring on fitting and
pull on tubing. (diagram 24 on next page)
To reattach, firmly push tubing back into fitting. If
tubing-fitting joint leaks because of frequent re-
moval, cut 1/2” off the tubing and reattach.
front adjust
left & right
adjust
left & right
adjust
rear adjust
diagram 23
diagram 24