Filter
Top Products
American Dispensing Company
88 Currant Road / Fall River, MA 02720-4781
12
IMPORTANT: The water vending machine must be connected to the electric supply shown on the
data label that is affixed to the back of the water vending machine, at the upper right
hand corner. In the case of 208 VAC or 230/240 VAC, the supply voltage must
match the electric service specifications of the data label exactly.
WARNING: 208 VAC and 230/240 VAC ARE NOT THE SAME. Any damage done to water
vending machine components due to improper voltage connections will automatically
VOID THE WARRANTY.
NOTE: ADC reserves the right to make changes in specifications at any time, without notice or
obligation.
F. UNPACKING/SETTING UP
ATTENTION: CHECK STATE AND LOCAL LAWS REGARDING THE OPERATION
OF WATER VENDING MACHINES BEFORE INSTALLATION. SOME
STATES REQUIRE VENDORS TO NOTIFY THE DEPARTMENT OF
PUBLIC HEALTH OR WEIGHTS AND MEASURES CONCERNING THE
INSTALLATION OF THE MACHINE. FOLLOW ALL APPLICABLE
FEDERAL, STATE AND LOCAL STANDARDS FOR DRINKING WATER
INSTALLATIONS.
ATTENTION: BE SURE THE INSTALLATION OF THIS MACHINE COMPLIES WITH
ALL LOCAL PLUMBING AND ELECTRICAL CODES.
WARNING: DO NOT CONNECT ELECTRICAL POWER TO MACHINE UNTIL
REQUESTED.
1. Remove the wrappings of the vending machine and check for transit damage. Notify carrier if there
is damage.
2. Skid can be removed by unscrewing four 5/16” skid bolts at the legs of the machine.
3. Place machine at the intended location and, if required, adjust the 3/4” bolts at the legs until the machine
is level and stable.
4. Connect plumbing inlet and outlet lines. Refer to guidelines in the section “SITE REQUIREMENTS.”
5. Reconnect R.O. membrane (see next page).