Filter
Top Products
20
PL02 - Dryness Level (drYL)
When in the automatic mode or free dry mode, the dryer will run until the preset level of dryness (Number of
Auto Peaks) has been reached. The dryness level is programmable from a minimum of 1 to a maximum of 99.
NOTE: Due to humidity, atmospheric pressure, water retention in the garment etc., the desired dryness
level may vary. It is suggested that the owner determine which level of dryness is best suited
for his application by experimenting with a few test loads.
PL03 - High Temperature (HIºF)
The high operating temperature is programmable from a minimum of 100º F (38º C) to a maximum of 190º F (88º
C) in ten-degree increments or from a minimum of 35º C (95º F) to a maximum of 90º C (194º F) in five-degree
increments.
PL04 - High Cool Down Temperature/Time (HICd)
The first part of this program controls the cool down temperature when the Phase 3 microprocessor controller
(computer) is used in the automatic or free dry mode. The cool down temperature is programmable from a
minimum of 100º F (38º C) to a maximum of 190º F (88º C) in ten-degree increments or from a minimum of 35º
C (95º F) to a maximum of 90º C (194º F) in five-degree increments.
The second part of this program controls the cool down time for both the automatic and timed modes. The cool
down time can be programmed from a minimum of 0 minutes to a maximum of 9 minutes.
NOTE: When the Phase 3 microprocessor controller (computer) is used in the automatic or free dry
mode, at the end of the drying cycle, the Phase 3 microprocessor controller (computer) then
starts the automatic cooling cycle for the cool down time programmed or until the temperature
has dropped to the programmed cool down temperature, whichever of the two (2) comes first.
PL05 - Low Temperature (LOºF)
Same as PL03 but for Low Temperature program.
PL06 - Low Cool Down Temperature/Time (LOCd)
Same as PL04 but for Low Cool Down Temperature/Time.
PL07 - Permanent Press (PPºF)
Same as PL03 but for Permanent Press.
PL08 - Perm Press Cool Down Temperature/Time (PPCd)
Same as PL04 but for Permanent Press Cool Down Temperature/Time.