Filter
Top Products
13
SECTION IV
OPERATING INSTRUCTIONS
NOTE: Unless otherwise specified at the time of ordering, the Phase 3 microprocessor controller
(computer) has been programmed by the factory with the parameters shown on
page 47 and
page 48. Should program changes be found necessary, please read this manual carefully to
thoroughly familiarize yourself with the Phase 3 programming characteristics.
A. TIMED MODE
1. When turning on power or when no cycle is in progress, the light emitting diode (L.E.D.) display will read
“FILL” and/or “Amount To Start” (“AtSt”).
2. Insert coin(s). Once the correct “Amount To Start” has been inserted, the L.E.D. display will read “PUSH.”
3. Select temperature by pushing “HI TEMP,” “LO TEMP,” or “PERM PRESS.” The dryer will start, and
the L.E.D. display will read the temperature cycle selected and the drying time.
4. The dryer will continue through the drying and cooling cycles, showing time counting downward.
NOTE: If the door is opened during a cycle, both the heat and motor will stop. However, the Phase 3
microprocessor controller (computer) will continue to count down in time. Continuation of the
cycle will resume only after the door has been closed and any one of three (3) temperature
selection buttons is again depressed.
5. Upon completion of the drying and cooling cycles, the buzzer (tone) will sound, and the L.E.D. display will
read “donE” for 5-seconds, at which time the dryer will shut off.
NOTE: If the Antiwrinkle Program is active (“Grd”), the L.E.D. display will remain reading “donE,”
and the Phase 3 microprocessor controller (computer) will proceed through the Antiwrinkle
Program until the maximum “Guard On Time” has expired or until the door is opened,
whichever comes first. The L.E.D. display will read “FILL” and/or “Amount To Start”
(“AtSt”).
NOTE: If the Antiwrinkle Program is not active (“nGrd”), the L.E.D. display will read “donE” until the
main door is opened, at which time the L.E.D. display will read “FILL” and/or “Amount To
Start” (“AtSt”).
B. AUTOMATIC MODE
1. When turning on power or when no cycle is in progress, the L.E.D. display will read “FILL” and/or
“Amount To Start” (“AtSt”).
2. Insert coin(s). Once correct “Amount To Start” has been inserted, the L.E.D. display will read “PUSH.”