Filter
Top Products
With the appliance installed adjust all four feet ensuring the machine is
stable, and a clearance of approximately 5 mm is left between the top of
the machine and the underside of the worktop.
A final check for stability should be carried out with the machine on spin with
a load, this will identify the need for any further fine adjustment to the feet.
A strip of beading approximately 605 mm W, x 5 mm H, x 25 mm D must be
screwed down into the base directly in front of the machine’s feet, this will
provide additional security.
If required an additional door magnet, part number 1242394-00/3 and disc,
part number 1242393-00/5 are available from spare parts.
54
Building-inInstallation
132984470.qxd 09/10/2006 10.12 Pagina 54