Filter
Top Products
34
Something not working?
Problem
The machine does not
empty and/or does not spin
Possible cause
The drain hose is Check the whole length of
squashed or kinked (E20). the hose and remove the
kink.
The drain filter (EF0) or the Clean the filter or check
drain hose are clogged (E20). the hose.
The RINSE HOLD option Empty out the water by
(stop with water in drum) selecting the drain or spin
has been selected. programme.
The laundry is not evenly Redistribute the laundry
distributed inside the drum. manually in the drum.
There is water on the floor
Too much detergent has Measure detergent
been used. according to the
manufacturer’s instructions.
An unsuitable detergent Use a suitable washing
has been used that machine detergent.
creates too much foam.
One of the connectors on Check that the hose is
the water inlet hose is firmly screwed on at both
leaking. ends.
The drain filter has not Fully screw the filter into
been properly screwed on place.
after cleaning.
Solution
The machine does not fill
The water tap is closed (E10). Open the water tap.
The water inlet hose is Check the whole length of the
squashed or kinked (E10). hose and remove the kink.
The small filter of the water Clean the filter.
inlet hose is clogged (E10).
The door is not properly Close the door.
closed (E40).
The machine fills then
empties immediately
The end of the drain hose Place the hose at the right
is too low. height (see Installation
section).
132984470.qxd 09/10/2006 10.12 Pagina 34