Filter
Top Products
b) Hinges
To mount the hinges it is necessary to
drill two holes (dia. 35 mm, depth
12.5-14 mm) on the inner side of the
door. The distance between the holes
hobs fixing centres must be 416 mm.
The distance (B) from upper edge of
the door to the centre of the hole
depends on the adjacent furniture's
dimensions.
The required dimensions are given in the picture C.
The hinges will be fixed to the door by means of screws for wood (2-Fig. B) sup-
plied with the appliance.
c) Mounting the door
Fix the hinges (1) to the machine by means of
the M5x15 screws (3-Fig. B). The hinges can be
adjusted to compensate for possible uneven
thickness of the door.
To align the door perfectly it is necessary to
loosen the screw (3-Fig. B), adjust the door and
tighten the screw again.
d) Counter-magnet (6)
The appliance is pre-arranged for a
magnetic closure of the door. To
enable a correct operation of this
device, it is necessary to screw the
counter-magnet (6) (steel disk +
rubber ring) into the inner side of
the door.
Its position must correspond to the
magnet (4) on the appliance (see
picture D).
If the door has to be opened from left to right, invert the position of the
plates (7), the magnet (4) and the plate (5) (Fig. B and E). Mount the coun-
termagnet (6) and the hinges (1) as previously described.
Important: the plastic screw (8) should never be loosened (Fig. B and E).
52
Building-in
35 Ø 12.5-14 depth
16-22
B
C
22+1,5
595-598
416
C
6
4
8
D
4
6
5
1
2
3
7
8
E
132984470.qxd 09/10/2006 10.12 Pagina 52