Filter
Top Products
When discharging into a stand-
pipe ensure that the top of the
standpipe is no more than 90
cm (35.4'') and no less than 60
cm (23.6'') above floor level.
The drain hose may be extend-
ed to a maximum of 4 metres.
An additional drain hose and
joining piece is available from
your local Service Force Centre. The joining piece must have an internal
diameter of 18 mm.
2. Onto a sink outlet spigot.
If the outlet spigot
has not been used
before, remove any
blanking plug that
may be in place.
Push the drain hose
onto the spigot and
secure with a clip if
required, ensure a
loop is formed in the drain hose (see diagram) to prevent waste from the
sink entering the washing machine.
The drain hose may be extended to a maximum of 4 metres. An additional
drain hose and joining piece is available from your local Service Force Cen-
tre. The joining piece must have an internal diameter of 18 mm.
If you intend the drain hose from the machine
to empty into a sink, make sure that the sink is
empty and the plug hole is not blocked. Use
the plastic “U -Piece” supplied.
Important
Before connecting up the machine to new pipework or to pipework that has
not been used for some time, run off a reasonable amount of water to flush
out any debris that may have collected in the pipes.
48
Installation
3 pin
Min. 60 cm (23.6)
Max. 90 cm (35.4)
Loop
132984470.qxd 09/10/2006 10.12 Pagina 48