Alphabetical reference Commands and Queries Reference
*TST? initiates a self-test of the XMP 2600 main control circuits. The tested
areas are: Controller Internal RAM, Tables Storage RAM, Settings
Storage Areas and Buffers RAM. The result of the self-test is reported
as a decimal number in the range 0 to 16 representing the bits of the
result register.
Syntax *TST?
Parameters none
Category System Type: Sequential
*WAI prevent the XMP 2600 from parsing any further commands or queries
until all pending operations have finished.
Syntax *WAI
Parameters none
Category Synchronization Type: Sequential
ARM program a Power Module to the Armed state in which further SET,
PROT and POL programming will be stored with no immediate effect
of the output of the Power Module.
Syntax ARM <ch>
Parameters the number of the channel to be armed.
Category Trigger and Sync Type: Sequential
ARM? return the state of the Power Module. The value returned is “0” if the
module is not armed and “1” if it is.
Syntax ARM? <ch>
Parameters the number of the channel to be queried.
Category Trigger and Sync Type: Sequential
BUFCLR empty the Output Queue.
Syntax BUFCLR
Parameters none
Category System Type: Sequential
CALDT? return the Calibration Date of a Power Module. The response is an
unquoted string with the following format: dd/mm/yy where: dd is the
day of the month, mm is the month and yy is the last two digits of the
year.
Syntax CALDT? <ch>
Parameters the number of the Channel to be queried.
Category Status Type: Sequential
44 XMP 2600 Programming Manual rev. 1.1
