Commands and Queries Reference Alphabetical reference
*SAV stores settings of all the Power Modules (same as STO command).
Syntax *SAV <int>
Parameters a decimal number in the range 0 to 9 specifying the
storage number the XMP 2600 will store the settings
in.
Category System Type: Sequential
*SDS initialize the contents of a storage area (causing it to be empty).
Syntax *SDS <int>
Parameters a decimal number in the range 0 to 9 specifying the
storage number the XMP 2600 will initialize.
Category System Type: Sequential
*SRE assign new value to the Service Request Enable Register. Re-
calculates <rqs>.
Syntax *SRE <int>
Parameters the value to be assigned to the Register - a decimal
number in the range 0 to 255 representing bits in the
Register.
Category Status Type: Sequential
*SRE? return the value of the Service Request Enable Register. The value
returned is a decimal number in the range 0 to 255 representing the
bits of the Register.
Syntax *SRE?
Parameters none
Category Status Type: Sequential
*STB? return the value of the Status Byte Register. The value returned is a
decimal number in the range 0 to 255 representing the bits of the
Register.
Syntax *STB?
Parameters none
Category Status Type: Sequential
*TRG toggles the state of the Global Output Enable Flag.
Syntax *TRG
Parameters none
Category Trigger and Sync Type: Sequential
XMP 2600 Programming Manual
rev. 1.1 43
