DS2100 User's Manual (Preliminary) SECTION 3: WIRING AND INSTALLATION
PAGE 3-48
3.11.3 Motor Brake Connection
The DS2100 provides a motor break relay at connector J2D (on Control Card Interface). The user supplies a 24Vd.c.,
Power Supply Unit for the brake connections. Details of the motor brake current requirements are available from the
relevant motor datasheet.
Motor Brake
Connector
Figure 3.33 Motor Brake Connector Location
J2D
1 24V DC
2 +
3 -
4 24V RET
User
Supplied
24V PSU
Motor
Power
Cable
*
Figure 3.34 Motor Brake Cabling
- Fixed connector: 4 pins, male connector
- Mating connector, 4 pins spring cage, female, supplied with the drive. Phoenix Contact (Part # FK-MCP 1.5/4-ST-
3.81)
- Wiring: cable. 28-16AWG (0.14-1.5mm
2
)
- Wire stripping: 9 mm
Pos.
Name
Function
J2D.1 24V DC Brake 24V Supply
J2D.2 + Brake +
J2D.3 - Brake -
J2D.4 24V RET Brake 24V Supply Return
Table 3.22 J2D, DS2100 Brake connector
* The pins of the brake terminals at the motor cable connector end depend upon the cable size. Refer to Figure 3.35 for
details.
