Inter-Tel 3000
Administrator’s Manual
107
The default is Wink Start
Programming Received Digits on the T1
If Received digits is selected the display updates to show the equipped T1 lines.
• From the programming extension, press the PROGRAM key.
• Press the Scroll Down key () until “System Programming” is displayed.
• Select “System Programming”.
• Enter the System Programming Password and select “Lines”.
• Press the Scroll Down key () until “T1 (RBS) or PRI (ISDN)” is displayed.
• Select T1 (RBS).
• Select “Received Digits”.
• The menu displays all the equipped lines.
• Select the required line.
• When a line is selected the display shows the current setting for 2 seconds.
• After the 2 seconds the programming range is shown on the top line of the display.
Up to 32 digits can be received between ANI and DNIS. The default setting is 2 digits.
Programming the Line Gain on the T1
If Line Gain is selected the menu updates to show the T1 lines.
• From the programming extension, press the PROGRAM key.
• Press the Scroll Down key () until “System Programming” is displayed.
• Select “System Programming”.
• Enter the System Programming Password and select “Lines”.
• Press the Scroll Down key () until “T1 (RBS) or PRI (ISDN)” is displayed.
• Select T1 (RBS).
• Select “Line Gain”.
• The menu displays all the equipped lines.
• Select the required line.
• The menu updates to show the options available.
• Select either “Low”, “Medium” or “High”. A solid diamond indicates the current setting.
The default is that all lines are set to high -3dB.
Note: Low is the recommended receive setting as specified in EIA 464C. Medium is the recommended
value in EIA 464B.
Programming DTMF/Pulse Dialing on the T1
Either DTMF of Pulse Dialing can be selected for the T1 channels.
• From the programming extension, press the PROGRAM key.
• Press the Scroll Down key () until “System Programming” is displayed.
• Select “System Programming”.
• Enter the System Programming Password and select “Lines”.
• Press the Scroll Down key () until “T1 (RBS) or PRI (ISDN)” is displayed.
• Select T1 (RBS).
• Select “DTMF/Pulse Dialing”.
• The menu displays the two options, “DTMF Dialing” or “Pulse Dialing”.
• Select “DTMF Dialing” option.
• The menu updates to show all the equipped lines.
• Select the lines to set as DTMF Dialing.
• When Pulse Dialing is selected the menu updates to show all equipped lines.
• Select the lines to be set as “Pulse Dialing”.
In default all lines are set to DTMF dialing.
