Filter
Top Products
ALIGNMENT AND ADJUSTMENTS
8
Quick Spin Test Mode
Denition of Quick Spin Test Mode:
- Quick Spin Test Mode is to do Spin Check. (High RPM)
How to Enter:
- During Service Mode, press the Pre Wash + Soil Level Keys for 3 seconds to enter Quick Spin Test
Mode.
- Cannot enter once the washing cycle has started.
Quick Spin Test Mode:
As it enters into the Quick Spin Test Mode, it starts spinning and reaches to its maximum RPM.
Once the Spin speed reaches the maximum RPM, the speed drops immediately.
To hold Quick Spin Test Mode (entering Hold Speed Mode), press the Start/Pause button. If the
Start/Pause button is pressed during Quick Spin Test Mode, it will stop accelerating and hold its
spinning speed for 10 minutes before going back to Quick Spin Test Mode.
Also, to cancel the hold and allow Quick Spin Test Mode to continue, press the Pre Wash + Soil
Level Keys together for 3 seconds.
If you hold down the Pre Wash + Soil Level Keys for three (3) seconds when the washing machine is
not in Hold Speed Mode, Quick Spin Mode is exited and Service Mode is restored.
To avoid risk of electrical shock, personal injury or death; disconnect power to washer
before servicing, unless testing requires power.
WARNING
Pre Wash + Soil Level
3 sec
While a cycle is not running
Pre Wash + Soil Level
While it is not in Hold Speed Mode
Pre Wash + Soil Level for 3 sec or after 10 minutes
WF395BTP-03144B-01_EN.indd 8 2012-10-19 �� 2:05:55