Filter
Top Products
d = Low water level
( = Medium water level
e = High water level
a= Intensive rhythm
b= Normal rhythm
c= Gentle rhythm
d= Sensitive rhythm
e= Ultra sensitive rhythm
f= Handwash rhythm
This machine has fully electronic
controls with automatic load
recognition. It takes in the right amount
of water required for the programme
depending on the amount of laundry
and its absorbency rate. This means
that programme cycles and durations
can vary.
The programme sequences outlined in
the chart are based on the basic
programme with a full load. Extra
options which can be selected have not
been taken into account.
The display shows the stage the
programme has reached.
Special features in the programme
sequences:
Anti-crease:
At the end of every programme, with
the exception of the Woollens
programme, the drum continues to turn
at intervals for up to 30 minutes to help
prevent creasing.
The door can be opened and laundry
removed at any time during the
anti-crease phase.
1)
A second rinse is carried out when a
temperature between 60°C and 95°C
has been selected. A third rinse is
carried out when a temperature
below 60°C is selected.
2)
A third or fourth rinse is carried out if:
– there is too much foam in the drum
– a spin speed lower than 700 rpm has
been selected
– The spin speed has been
deselected.
3)
A third rinse is carried out if:
–
The spin has been deselected.
4)
In the Outerwear programme,
laundry is only spun after the main
wash.
5)
Run-up to spin: A run-up to spin is
carried out before the wash process
begins, to deflate down-filled items.
Subsequent water intake for the main
wash is through compartment j.
6)
Pre-rinse: A pre-rinse without
detergent is carried out automatically
to remove dust.
Programme sequence
43