Filter
Top Products
Switching on
^
Close the door.
^
Open the stopcocks.
^
Press the I-0 switch.
When the programme selector is at f,
a dot lights up in the display.
Starting the programme
Choose your programme according to
the type of instruments or utensils being
cleaned and the degree of soiling.
The different programmes and their
uses are described in the Programme
chart at the end of this booklet.
^
Turn the programme selector
clockwise or anti-clockwise to the
required programme.
The temperature of the first stage of the
programme selected will appear in the
display, except with D and 6.
The indicator light next to the start
button 6 will flash.
Selecting the Drying 0 additional
function
The Drying additional function may be
selected immediately after the
programme has been selected (except
with Pre-rinse programme D).
To do this:
^ Press 0.
The programme will be extended by
Drying block 1 (if available) and 2; see
Programme chart.
The display shows programmed Drying
time 2. This can be altered in 5 minute
steps by pressing the 0 button.
The new drying time is programmed in
for the programme selected after the
programme start.
The total running time for the
programme increases accordingly.
^
Press the Start button 6.
The current temperature will appear in
the display.
The indicator light next to the Start
button 6 will light up.
Operation
36