Filter
Top Products
Problem Possible cause Remedy
White residues and/or
flecks are visible on
items.
The water softener is
programmed to a setting
which is too low.
Check the water hardness
level of the water supply and
programme the water
softener correctly.
Water entering the
machine through the AD
water connection is not
soft enough.
Change the resin in the aqua
purificator.
The salt reservoir is
empty.
Fill carefully with salt.
The salt reservoir cap has
not been screwed on
correctly.
Replace it making sure it
screws back on correctly.
The rinsing agent
reservoir is empty.
Add rinsing agent.
The rinsing agent dosage
has been set too low,
causing water marks.
Increase the rinsing agent
dosage setting.
The quality of the rinsing
water was not good
enough.
– Use water with a lower
conductivity level.
– If the washer disinfecter is
connected to a cartridge
for demineralised water,
check its condition and
exchange it if necessary.
Problem solving guide
65