Filter
Top Products
–
The DN 10 inlet hoses are approx.
1.7 m long terminating in a 3/4 inch
female thread. On no account must
the inlet filters be removed.
–
Large surface area filters are
enclosed in the kit supplied with the
machine for installing between the
stopcock and the inlet hose (see
illustration in "Maintenance -
Cleaning the filters in the wash
cabinet'"). The large surface area
filter for AD water is made from
chrome nickel steel, and can be
recognised by the matt top surface.
,
The inlet hoses must not be
shortened or damaged in any way
(see illustration).
See also the installation diagram
supplied.
AD water connection (pressurised)
ö 0.6-10 bar (60-1000 kPa) over
pressure
The machine is supplied as standard
for connection to an AD water supply of
0.6 - 10 bar (60 - 1000 kPa). If the water
pressure (flow rate) is below 1.5 bar
(150 kPa) the water intake time is
automatically extended.
^
The AD pressure tested hose
(marked "H
2
O pur") with a 3/4"
threaded union must be connected to
the on-site AD stopcock for purified
water.
,
If the AD water supply is not
used, the electronics must be
re-programmed by a Miele
approved service technician. The
inlet hose will remain on the rear of
the machine.
IMPORTANT
Australia and New Zealand.
This appliance must be installed
according to AS/NZS 3500.1. Back flow
prevention is already integrated in the
appliance.
Plumbing
75