Filter
Top Products
Problem Possible cause Remedy
The Add salt indicator
light k flashes.
The salt reservoir has not
been replenished,
meaning that the water
softener could not be
reactivated.
Fill carefully with salt.
A few minutes after the
start of a programme,
the p / 6 indicator
flashes and the
programme is
cancelled.
Before trying to rectify the
problem, you must:
–
Turn the programme
selector to f (the fault
code goes out).
–
Switch the machine off with
the I-0 switch.
Fault code: F..E:
There is a water inlet
fault.
–
Open the stopcock.
– Clean the water inlet filter.
– The water pressure at the
intake is too low. Ask a
plumber for advice.
Then:
– Switch the machine on.
– Start the programme
again.
Problem solving guide
61