Filter
Top Products
The lift door can only be opened when:
–
the lab glassware washer is
connected to the electrical supply,
–
the red ("emergency cut off") switch
is in the I-ON position,
–
the I-0 On-Off button is pressed in,
and
–
no program is running.
The lift door on the clean side (G 7828)
can only be opened when:
– DESIN (disinfection) programs have
been correctly completed,
or
– the Door interlock has been
activated, i.e. DOOR MECH. has
been set to one of the following
parameters:
- INTERLOCK,
- DOOR CLEAN+INTERLOCK,
- DOOR UNCL.+INT.LOCK.
(see "Machine function - Door
mechanism..." in the Programming
manual).
To open the lift door
^
Press the 5 door button. The lift door
rises.
,
Do not touch the heating
elements (under the wide area filter)
during or directly after the end of a
program, you could burn yourself.
If the boiler has been programmed
to "BOILER READY", be particularly
careful of hot water and steam when
opening the door. Danger of burning
or scalding. The water inlet pipe to
the wash cabinet is located, as
viewed from the unclean side,
underneath the basket runner on the
left hand side.
To close the lift door
^ Press the 5 door button. The lift door
lowers.
Opening and closing the lift door
15