Filter
Top Products
CHECK THESE POmNTS _F YOUR MAYTAG NEPTUHE ® WASHER,..
o Plug cord into live electrical outlet.
o Check fuse or reset circuit breaker=
° Close door and press the Cycle Selector dial to start the washer= For your safety, the washer
Stops will not tumble or spin unless the door is closed.
° Before the washer starts to fill, it will make a series of c[icldng noises to check the door loci<
and do a quick drain.
° This may be a pause or soak period in the cycle=Wait briefly and it may start.
° Check screens on k_[et hoses at the faucets for obstructions= Clean screens periodically=
° Turn both faucets on fully.
o Make sure temperature selection is correct.
Fills with the
Wrong o Make sure hoses are connected to correct faucets. Flush water lines=
Temperature ° Check the water heater. It should be set to deliver a minimum [20 ° F (49 ° C) hot water at
Water the tap=Also check water heater capacity and recovery rate=
o Disconnect hoses and clean screens. Hose filter screens may be plugged.
o As the washer is filling, the water temperature may change as the automatic temperature
control feature checks incoming water temperature=This is normal.
° While the washer is filling, you may notice just hot and/or iust cold water going through the
dispenser when cold or warm wash temperatures are selected. This is a normal function of
the automatic temperature control feature as the washer determines the temperature of the
water.
Won't tumble ° Check fuse or reset circuit breaker.
° Close the door and press the Cycle Selector diak For your safety, the washer will not
tumble or spin unless the door is dosed.
o Press the Cycle Selector dial to stop the washer=
Door locked shut;
° The washer door will remain locked during the heating portion of the Sanitary Cycle
wi|[ not open (select models).
° It may take a few moments for the door loci< mechanism to disengage=
The washer does o Check fuse or reset circuit breaker.
not drain and/or ° Straighten drain hoses. Eliminate kinked hoses. If there is a drain restriction, call for service.
spin ° Close the door and press the Cyc|e $e|ector dial. For your safety, the washer will not
tumble or spin unless the door is dosed=
° Use the High or Max Extract spin speed=
Load is too wet o Use high efficiency detergent to reduce over-sudsing.
at end of cyc[e ° Load is too small. 'Very small loads (one or two items) may become unbalanced and not spin
out completely.
° Make sure door is firmly closed.
Leaks Water o Make sure hose connections are tight.
o Make sure end of drain hose is correctly inserted and secured to drain facility.
, Avoid overloading.
, Use high efficiency detergent to prevent over-sudsing.
, Use high efficiency detergent to prevent over-sudsing.
Excessive Suds
" Reduce detergent amount for soft water, small or lightly soiled loads=
For further assistance, call Maytag Customer Service toll-free at 1-800-688-9900 USA or 1-800-688-2002 Canada=
U=S=customers usingTTY for deaf, hearing impaired or speech impaired, call 1-800-688-2080=
M3