Filter
Top Products
TORING THE CLOTHES WASHER
Washers can be damaged if water is not removed from hoses
and internal components before storage. Prepare the washer
for storage as follows:
o Select the Quick Wash cycle and add bleach to the
automatic dispensen Run the washer through the cycle
without a loa&
o Turn the water faucets off and disconnect the inlet hoses.
Disconnect the clothes washer from the electrical sup-
ply and leave the washer door open to let air circulate
inside the tumbler.
[f the washer has been stored in below-freezing tem-
peratures, allow time for any water left over in the
washer to thaw out before use.
For information on long-term storage or storage of your
washer during extreme coJd temperatures,
call Maytag Customer Service toll-free at
1-800-688-9900 USA or 1-800-688-2002 Canada.
U.S. customers using TTY for deaf, hearing impaired or
speech impaired, call 1-800-688-2080.
CHECK THESE POmHTS mE YOUR MAYTAG NEPTUNE ® WASHER...
Freshening your . See Cleaning the Interior, page I I,
washer
° Hake sure door is firmly closed.
The washer will not , blake sure the washer is plugged in.
start o blake sure the water source faucets are turned on.
o blake sure to press the Cycle Selector dial to start the washen
o Hake sure the Control Lock is not activated, see page 6.
" Before the washer starts to fill, it will make a series of clicking noises to check the door lock
and do a quick drain.
No water or insuffi- Turn both faucets on fully.
dent water supply Hake sure the door is tightly closed,
Make sure the washer is plugged in.
Check fuse or reset circuit breaken
Press the Cycle Selector dial to start the washer.
Straighten water inlet hoses.
Disconnect hoses and clean screens. Hose filter screens may be plugged.
Open and close the door, then press the Cycle Selector dial.
Detergent remains in . blake sure the washer is running with sufficient water pressure.
the automatic dis- See Installation Instructions.
penser after the wash o Make sure the Detergent Selector is in the upper position when using granular detergent.
cycle is complete
Washer vibrates or . blake sure the washer is set on a level surface. If the surface is not level, adjust the washer
is too noisy feet to level the appliance. See Installation Instructions.
o Make sure that the shipping bolts are removed. See Installation Instructions.
o Make sure the washer is not touching any other object.
o Make sure the laundry load is balanced.
CONT.
M2