Filter
Top Products
Secure the other ends of the security brackets (2) to the support using #10 hex head screws provided in
the miscellaneous partspackage. (See figure 56.)
i
Figure 56
If appliance has not been leveled, move it into position, check it with a level and makethe necessary
adjustmentsto the leveling legs. Once level, tighten the leveling leg locking nuts with a wrench.
Connectthe exhaust ducts to duct work by insertingthe elbow while holding onto the exhaust seal.
(See figure 57.)
Figure 57
25. Removethe tape and cardboard protectionfor the door on the lower dryer.
Page 22