Read this before you start...
TOOLS needed for installation
• Teflontape or pipe joint • Level
compound (gas) • Screw driver (standard)
• Cutting knife • Duct tape
• Pipe wrench (gas) • Crescentwrench
• Ratchet • 3/8" deep well socket
___,(_)_1 • 5/16" socket (electric- U.S. only)
• 5/16" nut driver
Electric Washer/Dryer Only Gas Washer/Dryer Only
ITEMS PROVIDED 0
Make sure you have everything necessaryfor proper installation.
1. GROUNDEDELECTRICAL OUTLET is required. See Electrical Requirementsstarting on page 6.
2. POWER CORDSfor electric dryers (except Canada).
3. GAS LINES (if a gas dryer) must meet Nationaland Local Codes.
4. EXHAUST SYSTEM- use rigid metal or flexible metal exhaust ducting. See Exhaust Requirementsin
this section.
5. UTILITIES SHUT OFFS (electric, gas and water) must be accessible after installation.
NOTE: Dryerdoor reversal instructions are on page 23 items 58 and 59.
27V2"
I, 69.9 cm • I
27"
Location Location
of Canadian of Canadian
terminal terminal
block
block
(electric 1 _8,:_,._
models) .v _,.,} Dryer
/
_5/16" _cationo yer terminal I,
2.4 block on electric models _' ___ L- 3/4"
and power supply cord _ I-tl.9 cm
Connection on gas moaeJs _,'_
Gas Manifold (except Canadian)
--,. . 1_18"
711/2" 2.9 cm
81.6 cm
3/8"rain. Washer
395/32" .95 cm
washer water I 27_/2"
washer drain hose valve connections 69.9 cm
Page 1