16. Insert the base to support brackets (removed in step 11) on both sides the upper base and secure with
the screws also removed in step 12. (See figures 38 & 39.)
.... " _" o ppL'u--or"
\\\
\\
Dryer _\_ -\
Base - _
"/ Tab /_
...., _; Screw
,\
Figure 38 Figure 39
17.Raise gas pipe with shut off valve up and secure to gas valve union• (See figure 40.) Tighten fitting
with a crescent wrench being careful not to over tighten. (See figure 41.)
Do not apply teflon tape or pipe sealing compound to the threads of the shut off valve. This is a
brass expansion sleeve fitting.
Figure 40 Figure 41
Page18