Filter
Top Products
31
Cleaning the pump filter
The pump has a filter to trap foreign objects that enter the
washer along with clothing. The pump filter can be accessed
from the front of the washer.
To clean the filter:
This should be cleaned out approximately once a month.
1
Turn the power off and unplug the machine.
2
Use a coin to open the filter cover. Place the edge of the coin
into the slot and tilt upwards whilst levering the cover open.
3
Unhook the pump outlet hose and pull it out (about 150mm).
Remove the plug and allow any water (approximately
250mls) to drain into a shallow dish.
4
After the draining process is complete, replace the plug into
the hose and refit the hose back into the housing.
5
Remove the filter by turning anti-clockwise. Clean and rinse
under a tap.
6
Replace the filter by turning clockwise until the white mark on
the filter is in line with the white line on the pump housing.
White mark on filter must be in line with white line on pump housing
white marks are in line
Correct
Incorrect
white marks are not in line
7
Close the filter cover.
CARING FOR YOUR WASHER
Drain residual water
Replacing filter