Fisher & Paykel WH7060J Washer User Manual


 
19
SAFETY FEATURES
Door lock
The door of your washer is locked once you touch until the machine beeps at
the end of the cycle, ensuring safety for you and your family while your machine is
operating.
To unlock the door during the cycle
You can open the door to add or remove items during the wash simply by touching
the button. Note: the door will remain locked if the temperature inside the washer is
above 60°C and/or the water level is above the bottom of the door seal (a warning will
be displayed in these circumstances, refer to ‘Before you call for service’).
Simply touch , the machine will pause and the door will automatically unlock if the
conditions inside the washer are safe. The button and time to go will flash on the
screen while the washer is paused. Open the door and remove or add garments. Close
the door and touch to resume the cycle.
Add a Garment (WH7060P, WH8060P models only)
The ‘Add a Garment’ function can be used to interrupt the cycle to add or remove a
garment at anytime during the wash (as long as the wash temperature selected for the
cycle is lower than 60°C). Water in the machine will be drained to a level where the door
can be opened, if necessary. Refer to ‘Wash cycle options’ for more information.
Opening the door during a power failure
If there is a power failure during a wash cycle your
washer will stop and the door will remain locked. You
can unlock the washer door to remove your clothes
by opening the pump filter cover at the bottom right
of your washer. Simply place a coin or key in the slot
and tilt it upwards to lever the cover open, then pull
the door release tab.
ImpORTANT!
Do not attempt to do this if the water level in the
washer is above the level of the door.
When power is restored you will need to restart
your machine by simply pressing . The washer will
remember where in the cycle it was up to.
Your washer also has the following protective measures:
Flood protection – turns off valves and turns pump on if a flood condition is detected.
Out-of-balance protection – stops and redistributes the load if an unbalanced load
condition is sensed, and/or slows the spin speed to compensate.
Excess suds protection – pauses to allow suds to break down before continuing the
cycle.
Door release tab
Manual door opening mechanism