Filter
Top Products
8
INSTALLATION INSTRUCTIONS
Location
ImpORTANT!
Install the machine on a solid and level floor surface ensuring it has at least 20mm
clearance on each side. The washer must not be installed on any textured floor
coverings (eg carpet, rugs).
Levelling the machine
It is IMPORTANT to level the machine to ensure good spin
performance, and to minimise noise, vibrations and wear
and tear on the washer.
1
Before positioning the machine in its final position, check
that the machine is level, front to back and side to side.
2
Manoeuvre the product into its final position (we suggest a
minimum clearance of 20mm each side).
3
Use a spirit level to check that the machine is correctly
level. If needed, pull the machine out and wind the feet up
or down to correctly level the machine.
4
Using the spanner provided, tighten the lock nuts against
the base of the machine to lock the feet in position.
Connecting to the water supply
Inlet hoses
ImpORTANT!
New hose sets provided with the washer should be
used to connect the washer to the water mains.
Old hose sets should not be re-used.
We recommend the inlet hoses are changed every
5 years. WARNING: Failure to do so may result in a
flood and damage to property.
1
Connect the straight ends of the inlet hoses to the taps
and the elbow ends to the corresponding machine inlet
valves. The hot valve is colour coded orange to make
this easier. Make sure there are no kinks in the hoses.
2
Turn the taps on and check for leaks. Check for leaks
again after 24hours.
ImpORTANT!
The hot water temperature should not exceed 65°C and the cold water temperature
not exceed35°C. Temperatures above these may cause the machine to fault or cause
damage to the machine.
Locking the feet
Inlet hose ends
Elbow
(machine) end
Straight
(tap) end