Filter
Top Products
3
Inlet hoses
1
Connect the straight ends of the inlet hoses to the taps.
There are washers fitted in both ends.
2
Connect the elbow ends of the inlet hoses to the machine inlet
valves. Inlet valves are marked on the back of the machine
H=Hot C=Cold
3
Ensure you have correctly connected hot to hot, and cold to cold.
Cold supply only:
If you only have a cold water supply, an inlet valve cap (blanking cap) MUST be connected to
the hot inlet valve. The cap prevents water leaking out of the hot valve. The cap is available from
your Fisher & Paykel Dealer or Authorised Repairer, Part No. 388491. This appliance incorporates
backflow protection complying with AS3500.1. No further backflow protection is required for
connection to the water supply.
Levelling
It is IMPORTANT to level the machine to ensure even
spin performance.
1
Separate the four rubber foot inserts from the moulding
and fit into the feet on the base of the machine.
2
Move the machine to its final position (we suggest a
minimum clearance of 20 mm each side).
3
Adjust the feet (wind down) so the machine is level and
cannot rock.
To check if your machine is level:
Look down on the wash bowl and make sure it sits slightly forward of centre. Close the lid.
Visually check that the lid fits evenly on both sides (see Fig.5). If not, adjust one of the front feet
slightly until it matches. The diagram on the top and bottom are not correct.
4
Turn on the water and check all hose connections for leaks. Make sure there are no kinks in the hoses.
5
Uncoil power cord, remove and discard the plastic pin cover and plug into wall socket.
Installation instructions
Adjustable feet
Corner cabinets
Rubber insert
Fig.3 Inlet hose ends
Machine end
Tap end
To check levelling look
down on the wash bowl
Correct
Incorrect
Fig.5 To assess levelling check lid alignment
Lid Alignment
Lid
Topdeck
Lid
Lid
Topdeck
Topdeck
Wind right foot down
(out) to correct
Wind left foot down
(out) to correct
Fig.4 Adjusting levelling feet
4323_NZ_AU_PAC_GW_MW_Washer_UG11.indd 3 8/10/09 2:45:22 PM