Filter
Top Products
27
Machine information
When you have finished
Turn off the taps to prevent the chance of flooding
should a hose burst.
Turn off the power at the wall.
Cold water washing
If you always use cold water, we recommend that
a WARM or HOT wash be used at regular intervals,
eg every 5th wash should be at least a warm one.
Cleaning your Smart Drive™
Clean with a soft damp cloth and wipe dry. Do not use
scouring cleaners as they can damage the paint, plastic
and panel surfaces.
Clean the fabric softener dispenser after each cycle using
warm soapy water.
You can remove the lid for cleaning. Open the lid fully,
hold one side with one hand and gently tap the other side
with an upward motion.
To replace the lid, hold the lid vertically and align both
hinges before pushing down firmly.
To remove the agitator for cleaning, unscrew the nut
down the centre of the agitator by turning anti-clockwise.
Important!
The agitator must be fully pushed onto the shaft when refitting. Tighten the nut firmly by hand.
Ensure the agitator is not loose.
Cleaning the inside of your Smart Drive™
If you use fabric softener or do regular cold water washing, it is important that you
occasionally clean the inside of your machine.
Fill your machine with hot water. Add about two cups of a powdered detergent.
Let it agitate for 10 – 15 minutes.
Stop the machine (press START/PAUSE), open the lid and leave it to soak overnight.
After soaking, drain the machine (advance to SPIN) and then run the machine through
a REGULAR cycle.
We do not recommend that you wash clothes during this procedure.
Fig.32 Removing the lid
4323_NZ_AU_PAC_GW_MW_Washer_UG11.indd 27 8/10/09 2:45:28 PM