Filter
Top Products
22
Changing pre-set options
Option adjustment mode
After using your Smart Drive™ you may want to fine tune some of the options to suit your
wash needs.
There are a number of pre-set options, which can be altered.
In the EXCELLENCE model the following pre-set options can be changed:
The wash temperatures.
The RINSE option on HEAVY DUTY and REGULAR cycles.
The COLD wash to CONTROLLED COLD.
The number of beeps at the end of the cycle.
The fill level selected by AUTO water level.
The out of balance recovery routine.
In the PRIDE model the following pre-set options can be changed:
The WARM wash temperature.
The RINSE option on HEAVY DUTY, REGULAR and WOOL cycles.
The out of balance recovery routine.
To enter option adjustment mode
1
Turn machine on at the wall but do not press POWER.
Press START/PAUSE and hold down, then press POWER.
You will hear two quick beeps and the machine will
show an unusual pattern of lights.
In this mode the lights are used to indicate the different
options available.
The diagram on page 23 shows how the lights relate to
the options you can change.
Pages 24 – 26 explain the different options in more detail.
2
Use the buttons on the panel to make your changes to
the pre-set options.
3
Press POWER to return to normal mode.
4
Your Smart Drive™ will automatically remember your
changes.
Fig.25 Entering Option Adjustment mode
Note: while EXCELLENCE model is shown,
setting of the PRIDE model is identical
EXCELLENCE
4323_NZ_AU_PAC_GW_MW_Washer_UG11.indd 22 8/10/09 2:45:26 PM