Filter
Top Products
15
Wash options
Soak
EXCELLENCE model only
Use the SOAK option to soak clothes at the end of the wash
phase or when you wish to re-use the wash water.
When you select SOAK your Smart Drive™ will soak for a period
of 2 hours before completing RINSE and SPIN. During SOAK
your Smart Drive™ will agitate for a few seconds every minute.
Nappy sanitisers/bleach
Nappy sanitisers and bleach are very corrosive to metal surfaces.
These should not be used in your machine.
Important!
DO NOT use your Smart Drive™ to soak items in bleach or sanitiser, or tip the contents of the
nappy bucket into your machine. The chemicals in these products can damage your washer.
Rinse and wring items out thoroughly before placing them in your machine.
Spin Hold
EXCELLENCE & PRIDE model
Use the SPIN HOLD option to:
Remove drip dry garments from a mixed load before the wash
goes into SPIN.
Minimise the clothes creasing when they are left to sit in the
bottom of the bowl at the end of the cycle.
When you have selected SPIN HOLD, your Smart Drive™ will
pause at the end of RINSE, beep and the SPIN light will flash
to tell you that it is waiting for another instruction.
Press START/PAUSE to begin the spin.
Delay Start
EXCELLENCE model only
DELAY START will delay the start of the wash cycle for 1, 3 or
9 hours.
Press DELAY START once for a delay of 1 hour. Press again for
3 hours, a third time for 9 hours (and again to return to normal).
Once you press DELAY START your Smart Drive™ will begin the
delay period, you do not have to press START/PAUSE.
Be careful if using DELAY START for non-colourfast clothes as
dyes may run if the clothes are damp.
Your Smart Drive™ will not beep at the end of the cycle if
DELAY START is selected.
EXCELLENCE
Fig.18 Selecting the SPIN HOLD
option
Note: while EXCELLENCE model is
shown, setting of the PRIDE model
is identical
EXCELLENCE
Fig.17 Selecting the SOAK option
Fig.19 Selecting DELAY START
4323_NZ_AU_PAC_GW_MW_Washer_UG11.indd 15 8/10/09 2:45:25 PM