Filter
Top Products
26
Changing pre-set options
Out of balance recovery routine
When your Smart Drive™ is spinning it can sense if the wash load is out of balance and will stop
and re-try spinning up to three times. If it still senses an unbalanced load there are two options
the machine can take.
Automatic recovery option
Your Smart Drive™ will try to automatically correct the out of balance load. It will fill with water
and agitate to redistribute the load before trying to spin up again.
Machine stops option
Your Smart Drive™ will stop, give a short burst of beeps every five seconds, and the RINSE or
SPIN light will flash. You must redistribute the load more evenly yourself (use this option if you
wish to conserve water).
Machine information
Specifications
Model Capacity Depth Width Height* Height (lid open)
WA75T65GW1 7.5 kg 650 mm 650 mm 1020 – 1050 mm 1410 – 1440 mm
WA65T60GW1 6.5 kg 600 mm 600 mm 1020 – 1050 mm 1360 – 1390 mm
WA55T56GW1 5.5 kg 560 mm 560 mm 1020 – 1050 mm 1320 – 1350 mm
WA55T56MW1
(MW512)
5.5 kg 560 mm 560 mm 1020 – 1050 mm 1320 – 1350 mm
Electrical Supply: 220 – 240 V, 50 Hz Sinusoidal, 165 W
Inlet Water Pressure: Max. 1 MPa (150 psi) Min. 34 Pa (5 psi)
Inlet Water Flow Rate: Min. 3 litres/min
Standpipe Height: 850 – 1200 mm
Note: exact height of your Smart Drive™ is dependent on how far the feet are inserted onto the
base of the machine.
* Height is measured to the highest point on the console.
Fig.31 Adjusting the Out of balance recovery routine
REGULAR
light on
= automatic recovery
REGULAR
light off
= machine stops
EXCELLENCE
REGULAR
light on
= automatic recovery
REGULAR
light off
= machine stops
PRIDE
4323_NZ_AU_PAC_GW_MW_Washer_UG11.indd 26 8/10/09 2:45:27 PM