Filter
Top Products
29
Quick Check
After replacing any part in the unit you can do a quick check to make sure that the unit is
working normal by following the procedure below:
• Checking Wash cycle - Set the washer knob to the Towels/Sheets position and
press the Power button, the unit will start filling in with water from both the inlet
valves, after a few minutes the unit stops to fill and the drum will start to agitate.
Then press the Power button, advance the knob to the Spin position and press
the power button the unit will pump out the water and begin to spin
simultaneously.
• Checking Dry cycle – Set the washer knob to the off position (End of the green
marking) and set a drying cycle for 30’. The unit will start heating up and you can
sense hot air in the drum.
e
Please Note: In this unit the door cannot be opened in the washing cycle
unless and until the washer knob comes to the Off position, however the door can
be opened at any time during the drying cycle.
********