Filter
Top Products
25
14) Heating Element (00745)
Replacement Procedure:
▪ Unplug the unit.
▪ Remove the top panel (Two screws behind and slide back)
▪ The heating element is located inside the heater housing.
▪ Unfix the support to the hater housing. (4 bolts on the top)
▪ Unfix the upper heater housing. (3 screws and a few clamps)
▪ Unfix the two nuts and remove the heating element.
▪ Replace the same and do the wiring as before / below.
▪ Fix all the parts back by following the reverse procedure.
Wiring: Heating Element
Testing Procedure:
▪ Hot Test:
1) Set the washer knob on off position and the dryer knob on 30.
2) You should get 115V AC across the terminals of the heating element.
3) Check if the unit is heating up, if so the heating element is good.
One end of the
fusible link
RA