Filter
Top Products
16
5) Hot water valve (00821)
Replacement Procedure:
▪ Unplug the unit.
▪ Remove the top panel (Two screws behind and slide back)
▪ Unfix the two screws at the back which hold the hot water valve.(Marked H)
▪ Remove the clamp to the hose.
▪ Replace with the new valve and do the wiring as before / below.
▪ Fix all the parts back by following the reverse procedure.
Wiring: Hot water Valve
Testing Procedure:
▪ Hot Test:
1) Set the washer knob to the Towels / Sheets position and switch on the unit.
2) You should get 115V AC between the terminals EVCX & EVC and the unit should start
filling in with water, it the unit does not start filling the valve is bad.
e
Please Note: The door should be locked properly and there should be enough
pressure to the water supply.
EVC
EVCX