Filter
Top Products
building-in electrolux 41
Drill four fixing holes see Fig. G
Position the base into the recess with its
front edge as far forward as the adjoin-
ing plinth line will allow.
The reason for placing the base in
this position is to allow a small strip
of beading to be fitted in front of the
appliance feet.
Fix the base firmly to the floor using four
appropriate countersunk screws (see
Fig. H).
600-605
5 X 25 X 605
Hardwood strip
5 mm x 25 mm
H
490
600-605 mm
50 mm
Front edge
Top view
95 mm
490 mm
G
With the appliance installed adjust all
four feet ensuring the machine is stable,
and a clearance of approximately 5 mm
is left between the top of the machine
and the underside of the worktop.
A final check for stability should be car-
ried out with the machine on spin with a
load, this will identify the need for any
further fine adjustment to the feet.
A strip of beading approximately 605
mm W, x 5 mm H, x 25 mm D must be
screwed down into the base directly in
front of the machine’s feet, this will pro-
vide additional security.
If required an additional door magnet,
part number 1242394-00/3 and disc,
part number 1242393-00/5 are avail-
able from spare parts.
132973260 EN.qxd 07/05/2007 15.18 Pagina 41