Filter
Top Products
17
TIME FOR TOP OFF 1 TO 99 MINUTES
This location determines the time that is vended once the AMOUNT FOR TOP OFF is met. This is programmable
from 1 minute to 99 minutes, in 1 minute increments. Each temperature setting has its own TIME FOR TOP
OFF so that each temperature setting can charge at a different rate.
TIME FOR TOP OFF is only used when the Phase 7 dual microprocessor controller (DMC) computer is set in
Accumulative Coin Mode. When a cycle is started, the Phase 7 DMC (computer) uses TIME FOR AMOUNT
TO START 1 TO 99 MINUTES to determine the initial amount of time vended for a temperature key. Once a
cycle is started, the Phase 7 DMC (computer) will then reference this TIME FOR TOP OFF for any additional
time needed, before any additional time is vended the user will first need to meet the AMOUNT FOR TOP OFF.
When a cycle is restarted from Pause Mode, the Phase 7 DMC (computer) will calculate how much time is left in
the cycle for the new temperature selected. These calculations are based on a combination of the TIME FOR
AMOUNT TO START and TIME FOR TOP OFF for the new temperature key selected and the amount of credit
that was available at the time the Phase 7 DMC (computer) was placed into Pause Mode. In Accumulative Coin
Mode, the AMOUNT TO START and AMOUNT FOR TOP OFF can differ, so the rate charged for TIME FOR
AMOUNT TO START and TIME FOR TOP OFF can be different. The Phase 7 DMC (computer) accounts for
the different rates by tracking how much credit is available from AMOUNT TO START and the credit that is
available from TIME FOR TOP OFF. Using these ratios of credit and time, the Phase 7 DMC (computer) will
determine how much time is left in the cycle for the new temperature key selected.
ENTER HIGH DRY TEMP 100 TO 190°F
Each temperature cycle “HIGH,” “MED,” and “LO” can be programmed to a dry temperature ranging from
100°F to 190°F (38°C to 87°C) in Radial Mode or 100°F to 150°F (38°C to 66°C) in Axial Mode.
COOL TIME 0 TO 9 MINUTES
Cool down time ranges from 0 to 9 minutes. The cool down time occurs at the end of a dry cycle. If your cool
down time is set to 4 minutes, the last 4 minutes of the dry cycle will be in Cool Down Mode.
PL #06 – VENDING PARAMETERS
CURRENCY SYMBOL
The Phase 7 DMC (computer) can be programmed to display ALL currency in one (1) of the following currency
symbols, a token mode, none, and no symbol or decimal point.
USD / UK Pound / EURO / Yen / Token / None / No Symbol or Decimal
NOTE: When the Phase 7 DMC (computer) is set to TOKEN ALL of the coin related menu items
will change from currency to whole numbers. The LEFT and RIGHT COIN VALUES will
change to a default of one (1) token. The AMOUNT TO START and AMOUNT FOR TOP
OFF will also default to one (1). If the currency symbol is changed back to a currency
symbol these menu items will change back to factory defaults. The default setting are
LEFT COIN DENOMINATION – 0.25, RIGHT COIN DENOMINATION – 0.10,
AMOUNT TO START – 0.25, and AMOUNT FOR TOP OFF – 0.25.