Filter
Top Products
17
e. Tumbler (Basket) Junction Box Disconnect
Remove the four (4) bolts that hold on the lower left side panel, then remove the panel. Next, remove the
safety panel by removing the six (6) bolts on the bottom of the panel where the tumbler (basket) section
and the base meet. Reach into the feed through hole in the base of the tumbler (basket) section, where
there will be two (2) cables there. Pull both cables through the hole into the tumbler (basket) section.
The cable with the connector on the end is for the tumbler (basket) junction box, the other cable is for the
left drum motor. Leave that cable in the tumbler (basket) section (it will be covered in Section f below
[Left Drum Motor]). Check keying between the plug and tumbler (basket) junction box. Insert plug into
connector on the junction box and engage locking clasps. Leave the lower left side panel and the safety
panel off the machine until left drum motor is reconnected (refer to Section f below [Left Drum Motor]).
f. Left Drum Motor
There are two (2) different ways that the left drum motor is connected with or without the motor
disconnected junction box. The junction box is used when the connections to the left motor are made on
the back side of the motor, nearest to the tumbler (basket). When connecting the motor, bring the left
drum motor cable (refer to Section e above [Tumbler [Basket] Junction Box Disconnect]) and
mechanically connect it to the junction box on the motor or the external junction box with the lock nut.
There will be four (4) wires in the cable, match them with the PVC electrical tape. There should be one
(1) green wire remaining, which is used for the ground connection. Replace the screws that go on the
cover of the junction box. Bolt the safety panel back in place using the six (6) bolts removed in Section e
above (Tumbler [Basket] Junction Box Disconnect), then bolt the lower left side panel back in to place
using the four (4) bolts also removed in Section e above (Tumbler [Basket] Junction Box Disconnect).