Filter
Top Products
15
c. Annunciator, Pendent, Over-Burner, and RTD (Resistive Temperature Device) Cable
Remove the four (4) bolts that hold on the character (464) panel. Open the door to the main electrical
enclosure, the female end of the RTD (Resistive Temperature Device) cable will be found there. Loosen
the 1-inch (2.54 cm) lock nut and remove the modified hole seal. Put the female end of the RTD cable
through the hole in the top of the electrical enclosure. Connect the male end and the female end of the
RTD cable together, pull the cable up until the threads of the reducing bushing can be seen through the
hole into where the character (464) panel was. Next, get the 1-inch (2.54 cm) lock nut on by a few
threads, slip the modified hole seal under the lock nut holding the 45° cord grip connector, then tighten the
1-inch (2.54 cm) lock nut. Replace the character (464) panel and tighten the four (4) bolts.