Filter
Top Products
IMPORTANT
You must disconnect and lockout the electric supply
and the gas supply or the steam supply before any
covers or guards are removed from the machine to
allow access for cleaning, adjusting, installation, or
testing of any equipment per Occupational Safety
and Health Administration (OSHA) standards.
Please observe all safety precautions displayed on
the equipment and/or specified in the installation
manual included with the dryer.
CAUTION
The dryer(s) should never be left unattended while
in operation.
“Caution: Label all wires prior to disconnection when
servicing controls. Wiring errors can cause
improper operation.”
«Attention: Au moment de l’entretien des
commandes, étiquetez tous les fils avant de les
débrancher. Des erreurs de câblage peuvent
entraîner un fonctionnement inadéquat et
dangereux.»
WARNING
Children should not be allowed to play on or near
the dryer(s). Children should be supervised if near
dryer(s) in operation.
Under no circumstances should the dryer door
switch(es), lint door/drawer switch(es), or heat safety
circuit(s) ever be disabled.
The dryer must never be operated with any of the
back guards, outer tops, or service panels removed.
Personal injury or fire could result.
The dryer must never be operated without the lint
filter/screen in place, even if an external lint collection
system is used.
FOR YOUR SAFETY
Do not dry mop heads in the dryer. Do not use
dryer in the presence of dry cleaning fumes.
The dryers must not be installed or stored in an
area where it will be exposed to water and/or
weather.
The wiring diagram for the dryer is located in the
front electrical control box area.
Proposition 65
Use of this product could expose you to substances
from fuel combustion that contain chemicals
known to the State of California to cause cancer,
birth defects and other reproductive harm.
▲ WARNING
!
Table of Contents
Section I
Safety Precautions ....................................... 4
Section II
Specifications ............................................... 6
Section III
Installation Procedures ................................ 8
A. Location Requirements .............................................8
B. Unpacking/Setting Up ................................................9
C. Dryer Enclosure Requirements .............................. 11
D. Fresh Air Supply Requirements ..............................12
E. Exhaust Requirements ............................................13
F. Electrical Information ...............................................19
G. Gas Information........................................................22
H. Water Information.....................................................25
I. Preparation for Operation/Start-Up ..........................26
J. Preoperational Tests ...............................................27
K. Preoperational Instructions .....................................28
L. Compressed Air Requirements ..............................30
M. Shutdown Instructions .............................................30
Section IV
Service/Parts Information .......................... 31
A. Service ......................................................................31
B. Parts..........................................................................31
Section V
Warranty Information ................................. 32
A. Returning Warranty Cards .......................................32
B. Warranty....................................................................32
C. Returning Warranty Parts.........................................32
Section VI
Routine Maintenance ................................. 34
A. Cleaning ...................................................................34
B. Adjustments .............................................................35
C. Lubrication................................................................35
Section VII
Manual Reset Burner Hi-Limit Instructions 36
A. Phase 7 ....................................................................36
B. Dual Timer................................................................36
Section VIII
Data Label Information............................... 37
Section IX
Procedure for Functional Check
of Replacement Components ..................... 38