Filter
Top Products
113409-2 www.amdry.com 29
The L.E.D. display will read MANUAL DRYING CYCLE D, 00:00 MIN REMAIN.
NOTE: The dryer can be stopped at any time by pressing the “STOP/CLEAR” key, at this time the dryer will
go into a cycle pause. If the “STOP/CLEAR” key is pressed again at this point, the cycle that was in
progress will be cancelled and returned to the “READY” state.
When the programmed drying time has expired, the Phase 7 non-coin microprocessor controller (computer) will
proceed into the Cool Down Cycle.
Once the Cool Down Cycle begins at the end of the heat cycle, the L.E.D. display will read COOL DOWN TEMP
___/___ MINUTES remaining. At the end of the heat cycle, the dryer will shut off the heat and continue the fan
and tumbler until the Cool Down Time or temperature is reached.
2. Dual Timer Dryers
Turn drying timer knob for a time of 20 minutes.
Select “High Temp.”
Push “Push to Start” button.
To stop the dryer, open the main door.
Spin and dwell (stop) times are adjustable at the reversing timer.
3.
Reversing Timer Spin/Dwell Adjustments
Timer models have an electronic reversing timer in the electrical service box, which is located in the upper left rear
area of the dryer.
Both the Dwell (stop) Time and the basket (tumbler) Spin Time are adjustable by mode selection switches located
on the electronic timer (as noted in the illustration below).
TIMING LEGEND
SPIN TIME
Adjustment Position Number 1 2 3 4 5
Time in Seconds* 30 60 90 120 150
DWELL (STOP) TIME
Adjustment Position Number 1 2 3 4 5
Time in Seconds* 5 6.3 7.6 8.9 10.2
* Values shown are +/- 1-second.