Filter
Top Products
RS3100007 Rev. 0 A–6
Important Safety Information
Save These
Instructions
Grounding Instructions
For safety, washer must be grounded. All washer power supply cords are
equipped with 3-prong grounding plug. Plug on cord must be plugged into
appropriate outlet that is properly installed and grounded in accordance
with all local codes and ordinances. Do not modify plug on washer cord.
If plug will not fit outlet, have qualified electrician install proper outlet.
WARNING
!
To avoid risk of personal injury or death due to electrical shock:
About Ground Wires
In the event of an electrical short circuit, a
ground wire reduces the risk of electric
shock by providing an escape wire for the
electric current.
Standard accepted color coding for ground
wires is green or green with a yellow
stripe.
Grounding wires and wires colored like
grounding wires are NOT to be used as
current carrying conductors.
Washer Dimensions
• Observe all local codes and
ordinances.
• Disconnect electrical power to
unit before servicing.
• Ground appliance properly.
• Check with a qualified electrician
if you are not sure this appliance
is properly grounded.
• DO NOT ground to gas line.
• DO NOT ground to cold water
pipe if pipe is interrupted by
plastic, non-metallic gaskets, or
other insulating (non-
conducting) materials.
• DO NOT modify plug on power
cord. If plug does not fit electrical
outlet, have proper outlet installed
by qualified electrician.
• DO NOT have a fuse in the
neutral or ground circuit. A fuse in
the neutral or ground circuit could
result in an electrical shock.
• DO NOT use an extension cord
with this appliance.
• DO NOT use an adapter plug
with this appliance.
• DO NOT pinch power cord.
36.6" (93 cm)
43.6" (110.7 cm)
2"
(5.1 cm)
H C
53.5"
(137.1cm)
26.9" (68.3 cm)
28" (71.1 cm)
Optional Kits
Kits are available at extra cost through
Amana dealer or Amana factory
1-800-843-0304.
Siphon Break Kit
For standpipe installation below 36"
(91.44 cm), install part #562P3.
Longer Water Inlet Hoses
8’ (2.44 m) inlet hose, part #20617.
10’ (3.05 m) inlet hose, part #20618.
Drain Hose Extension
Order this kit in two parts: the coupler,
part #406P3, and 1' additional drain
hose, part #20616.
Anchor Kit
To stop washer from moving on
uneven surfaces, install part #155P3.
Adjustable leg Extension Kit
To level washer on extremely uneven
surfaces, install part #566P3.