Filter
Top Products
RS3100007 Rev. 0 A–2
CONNECT
WATER FILL
HOSES TO
WASHER
Tightly push one flat rubber
washer into one end of each
water fill hose and attach this end
of hose to washer. HOT and
COLD connections are identified
by letters H and C stamped into
washer cabinet and by HOT and
COLD printed on water fill hoses.
MOVE WASHER
TO FINAL AREA;
REMOVE
SHIPPING BRACE
& PLUG
Protect the floor when moving the
washer. Washer must be within 4 feet
of desired area before beginning
installation. Open washer lid and
remove installation parts from
shipping brace for use.
Reach through foam shipping
brace, grasp bottom of brace, and
pull up to remove.
Installation
Instructions
Top Loading Washer
Keep instructions for future reference. Be sure manual stays with washer.
1
2
NOTE: Save shipping plug and
shipping brace; reinstall whenever
washer is moved more than 4 feet.
Do not lift or move washer without
shipping materials in place.
To remove the shipping plug from the
washer, step on the card board base,
tilt the washer back, and slide out the
base.
H C
HOT
COLD
Push rubber washer
into end of fill hose.
In most cases, hoses should
cross when attached to correct
water temperature faucet.
Tighten hose connections by hand
until snug, then another ¼ turn with
pliers. DO NOT cross-thread or over-
tighten couplings.
Cardboard
base
Shipping
plug
Shipping
brace