Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Installation
25
F232102
Mechanical Installation – Models
with Tilt Option
Mounting Bolt Installation for 250 Pound
Capacity Models with Forward or
Two-Way Tilt Option
NOTE: Models equipped with tilt option MUST be
anchored to the floor.
High-strength 1-16 x 10 inch machinery anchors
should be embedded in 3500 psi reinforced concrete
that is a minimum of 6 inch thick. Refer to Figure 14
for mounting bolt layout for 250 pound capacity
models with tilt option.
Figure 14
After the anchor bolts are installed and the concrete
has cured, proceed as follows:
1. Place the washer-extractor adjacent to the
foundation. Do not attempt to move it by pushing
on the sides. Due to the size and weight of the
250 model, appropriate equipment to lift and
move the washer-extractor must be available.
A rigging service is recommended.
2. Remove all panels on the tilt mechanism.
Remove the top covers of the washer-extractor
to gain access to the lifting points. Remove the
front and rear side panels on each side of the
washer-extractor. This will give access to the
shipping fasteners that tie the skid, tilt
mechanism, and the washer-extractor together
for shipping.
3. The shipping fasteners consist of four (4) 15-inch
threaded rods. Remove nuts and washers from
both ends of each threaded rod and remove each
rod from the washer-extractor. Retain the nuts
and washers for use later in the installation
process.
4. Using the appropriate equipment, lift the washer-
extractor away from the tilt mechanism and the
skid and set aside. Remove the tilt mechanism
from the skid. Dispose of skid properly.
5. Place the tilt mechanism carefully over the
anchor bolts. Appropriate equipment is needed to
lift the tilt mechanism and keep it in a horizontal
position while moving it into position.
CFS217N
66 in.
(1676 mm)
5 in.
(127 mm)
5 in.
(127 mm)
24 in.
(610 mm)
26.31 in.
(668 mm)
77.5 in.
(1969 mm)
1.25 in.TYP
(32 mm)
76 in.
(1930 mm)
89 in.
(2261 mm)
40.69 in.
(1034 mm)
74 in.
(1880 mm)
91 in.
(2311 mm)
23 in.
(584 mm)
89 in.
(2261 mm)
8 in.
(203 mm)
25.31 in.
(643 mm)
24 in.
(610 mm)
Damage to persons and property could
occur if the tilt mechanism is not kept in a
horizontal position.
W357
DANGER
Attempting to lift the tilt mechanism by
hand could result in personal injury and
damage to the tilt mechanism.
W358
DANGER